gauge

Seems like this is something that someone has asked before. Let me know if that is the case. I would like to install a high temp alarm on my 1985 Universal M-18. The only one I have found is on Catalina Direct. While fine boats, mine is a 1985 Ericson 30+. I spoke to the sells department at...

I removed my fuel guage today so I could order a replacement and when I took out the two screws I realized it was a fake gauge with no conection to the inside of the tank. Where is your fuel gauge? Mine is under the mattress in the aft cabin. There was nothing underneath but a cap...

My temperature gauge is busted, was busted all last summer. Promised myself this would be resolved before I go back in the water. Does anyone have a link to a good article on the trouble shooting steps to be find the problem? I have never looked at this part of the diesel system and have no idea...

On my 30+ the fuel gauge started only working if it was over half full. Then it stopped working all together. I naively hoped it was just a gauge problem since West Marine had them on sale for $20. No such luck. When the power is applied to the gauge it actually dips a bit more negative. I...

The previous owner of my E29 had disconnected the Water Temp gauge for the Universal A4--as he believed it had a short. I have searched the web for a wiring diagram for the four terminals on the back of the gauge--with no luck. I actually tried to remove the gauge from the panel but it seems...

Hi Folks, Has any one replaced their universal "gauge panel"? On our "88 E 34 it has been glassed in the corners and now that has given away and cracked all across the bottom and it just hangs there. To push the start buttons must lift the lazaret hatch and hold the back of buttons...

A friend of mine has an E-33 (1984) and the temp gauge has ceased to function. How does one verify that the temp sensing unit is sending a signal to the gauge, and can that signal be tested with a multi-meter? By the way, which Kubota block is the 1984 M-25? The D-950?

Does anyone know how the fuel gauge operates on the control panel of an Ericson 30+ with a 5416 Universal engine. When removing the panel there is no connection from the fuel gauge to the tank. when looking at the gauge and what seems to be the place where the tank sensor is it would seem that...

My temp gauge doesn't read until I turn off the key. Here's what I've tried so far: 1) new gauge; 2) new sending unit; 3) new thermostat conversion kit from Moyer Marine; 4) tried bypassing wire from sending unit to gauge - same result. The gauge reads below the extreme cold until I turn...

I currently have a nonfunctioning Sealand Tankwatch on the holding tank that I'm replacing. I don't know why it quit, but it did, perhaps the probe got gunked up -- I can't imagine it not. I'd like to replace it with something else and have been looking at the Acugage by Snake River, which...

has anybody upgraded there gauges and kept there old ones? need oil pressure gauge for 74 35 II thanks greg

Incorrect fuel tank gauges seems to be common problem. My 1987 E34 tank is supposed to hold 30 gallons. When I fill up the gauge will move only slightly until I crank up and then it moves begrudgingly to close to full but not quite. I use 11 gallons and the gauge shows slightly less than half...

Can anyone tell me where the fuel gauge is located for an Ericson 38-200 (or if it is an "option" that may or may not be present)? I have an 89 E-38-200 with a Universal Diesel. I've located the fuel tank, but can't seem to locate the gauge. Thanks in advance, Carol

TRYING TO FIND OUT IF ANYONE KNOWS WHAT IS CAUSING OUR RPM GAUGE TO BOUNCE AROUND AFTER IT GETS STARTED AND WARMED UP THIS HAS JUST RECENTLY BEGUN.