Recent content by Pete in Vermont

Hello--I have a 1987 Ericson 26. The sink in the head has two spigots. Both are connected directly to the water tank by separate flexible hose lines. One pump is a hand pump type. The other is simply a chrome fixture that is only a spigot. This has no faucet (or shut off valve) but the spigot...

Hello, everyone. Hoping you're enjoying decent early spring weather. I have a 1987 Ericson 26 (IV, I believe). I'd like to replace the main with a good basic sail, but this time one with full battens. Any recommendations for good, reasonably priced options? Thanks in advance for any help. Pete

Hi. I have a 1987 Ericson 26'. I am considering a voyage along the Hudson and into Long Island Sound. The addition of radar is highly recommended. I'd like to know what kind of radar units have worked for other folks with vessels of this type and size. (Many thanks in advance of your response!)

I have a 1987 Ericsson 26 with a Universal M12 engine. Although I replaced the ignition switch in the last year, I frequently encounter instances in which the starter will not respond. 4--5 attempts are often required before the starter engages. I'm asking that anyone who's experienced this let...

Varnish? I've had very good luck with Epiphanes products, notably the high gloss and the wood finish. It's advisable to follow the application schedules.

My Ericson 26 (1987) came exist with Isomat mast and boom. The diagrams for the boom's internal reefing arrangement do not match what I seem to have. The current set-up seems to lack the forward lines (or access for same) that can allow for single handed reefing. There are two lines (Reef 1 and...

The official manual for my 1987 E 26 is unclear (to me) about the mast height. The specs list the "I" measure (deck to top of mast as 30.5'. However, it also lists the "P" (boom to max height of main) as 31.5' . It would seem unlikely to have a mainsail luff longer than the entire height of the...

I want to replace the bulb(s?) on the mast of my 1987 E26 (III). This is an Isomat rig. If anyone has it, I'd like the type and parts # of the bulb before I hike up there. Any chance these are available in LED (12v)? Many thanks. Happy sailing!

Hello what is the currently recommend and available transmission fluid for a Universal M12? Thanks!

I own an Ericson 26. I'm wondering why this boat has a fractional rig. I understand why lighter race boats, especially smaller ones have fractional rigs, but not sure why the E26 does. Thanks for any thoughts on the matter.

Engine otherwise is running OK with no more than usual light gray smoke upon starting. Compression seems OK but have not yet run a test. Engine temp and oil pressure are OK. Will most certainly have the injectors tested. Apparently, there is no way to access the core of the injector fuel pump...

My 1987 Ericson 26 came with a Universal M 12. During the 3 seasons I've owned her, the motor has run well. Recently I note the significant increase in oil level after motoring for 4 hours. This does not have the milky/ creamy look of water intrusion. Techs tell me the most likely source is the...

Re: 1987 Ericson 26 III-- I have a dripless stuffing box. I have owned the boat for 2 seasons. All appears to be in order. I note that there is a hose ( about 3/8" ID) attached to the fwd end barb. This hose runs aft, but is not connected to anything at the aft end. What is the purpose,of this...

Hello, everyone, We'd like to add a Bimini to our Ericson 26, however, we note that the boom sits so low, this might be a tight squeeze. How have others dealt with this matter? Many thanks for any help in this regard. Fair winds. Pete

Thanks, Loren--all good advice! QUOTE=Loren Beach;93836]Nice writeup and pix in this vendor site. http://www.downwindmarine.com/Whale-Flipper-Galley-Hand-Pump-p-91000970.html Given that my '88 model boat had no provision for manual pumping of the fresh water for the head or the galley, I...