Recent content by exoduse35

  1. exoduse35

    heat exchanger pluged solid

    My a4 manifold has the water jacket plugged solid. A replacement is almost $500 at Moyers. Does anyone have suggestions for cleaning it out? As always thanks in advance, Edd
  2. exoduse35

    E35-II holding tank

    many of the early 35-2s did not come with a black water tank. It was not law until 1974. mine has the battery bank in the setae behind the bulkhead, and the holding tank under the port side setae. I have alsi heard of them being put under the port side of the v birth. .
  3. exoduse35

    E-35-2 Serial Number (New Owner)

    it it too early for the transom... it is on the ruder post. mine is 163
  4. exoduse35

    Water Tankage Questions, E-35-2

    the early 70's front tanks were stainless. both my front and floor tanks are stainless. E35 #163
  5. exoduse35

    Through hulls

    Don't lose sleep. Just have them closely inspect it (and everything else below the water line) before they cast off the slings. It will not sink in the slings, just take on water so Sleep! Edd
  6. exoduse35

    Video Logs of Large Scale Projects

    I have been following S/V Seeker for about a year and love it! For an Oaky redneck he is doing a great job at making me say "damn I could never do that" and making me feel guilty about not finishing all those little boat projects. Edd
  7. exoduse35

    liability insurance

    also check with your home owners insurance. The same coverage as boat US was about half when added by State Farm to my house insurance and they were not near the hassle. Boat US is VERY reluctant to take an older (like 10 years is old to them) boat and will want it beyond perfect to even...
  8. exoduse35

    Boat Identification. 36? 38? What year?

    I would put money on a 35-2. an anchor is cheep, but an engine will cost at least 3 times what that boat should sell for. You should be able to pick that boat up for 1, 2 grand tops even if all else is perfect on it. A new Beta diesel will set you back about 10 grand and a couple more if you...
  9. exoduse35

    looking for a roller furling for an e 35 -2 ?

    Just so you know, you are not the last one with hank on sails. Have them on my 35-2 and no plans to change. Edd:egrin:
  10. exoduse35

    Hanging storage for galley

    Dear Glyn, that is the beauty of hanging them in the open space above the bulkhead. Then there is onlu the tearable music they make in a seaway! Edd
  11. exoduse35

    Keel Damage

    Never say never... haven't yet has much better karma:0
  12. exoduse35

    Hanging storage for galley

    On my 35-2 the galley is on the other side but otherwise has that same short bulkhead arangement. I put a 2x2 post in from the top of the bulkhead to the cabin top. It worked out that a standard teak paper towel rack then fit perfectly from the post to the side wall below the window. The top of...
  13. exoduse35

    Interested in E35 ii (1972) , advice needed light air / open water performance

    I think you missed on the "no comparison" thing... Nothing compares to the 35-2! The 35-3 and 34-10 are a lot closer in hull shape. The 35-2 was built to exploit a specific set of racing rules and did so so well that the rules got re writen. It 's stated stats are corect, but only when at the...
  14. exoduse35

    Diesel advice needed

    Another thing to look at... A diesel will also belch white smoke if running lean. the injection pump is usually gear driven and precisely aligned with a dial gauge that reads in the thousandths of an inch. there Is a procedure of rotating the engine from TDC back to the lobe bottom in the pump...
  15. exoduse35

    Looking to replace what I believe is injection elbow?

    I am not familiar with that part or why it would be there, however it looks to be made from common plumbing parts. you should be able to reproduce it with a trip to the local hardware store. The small port would probably take some drilling and tapping. Or it may be that soldering it up from...
Top