ddoles
Member III
Has anyone tried to run wires for electronics through the horizontal members of the stern rail? I'm planning to install an external GPS antenna for a soon to be installed AIS. My thought was to mount the GPS on either the upper or lower stern rail. This would mean running a wire from inside the lazarette up into the stern railing, similar to the stern light wiring. However, the horizontal members do not terminate at the deck. I'm not sure if it is possible to run wires internally through the joints where the vertical and horizontal members are welded. Another option would be to run the wire up inside a vertical member and exit the wire and then have an external wire run for bit, but this is not elegant.
Would appreciate any advice.
Thanks,
Dave
Would appreciate any advice.
Thanks,
Dave