I am having a long standing problem with a leaky rudder packing. The way it is designed, the groove for the waxed linen is in the upper removable disk, flange, thingy, and the lower one (that is glassed into the rudder tube is flat on top). No matter how tightly I try to pack it with packing it spews when I am on a heel. I think part of the problem is excessive clearance as the bronze has worn leaving the shaft a little giggly. Has anyone come up with the sure fire way to wrap these things so that the bilge isn't soaked after a good sail?? I don't mind pulling the rudder if I have to. IS there a modern aftermarket thing that will replace this wet union on an older boat without guting out the entire rudder tube? Thanks in advance for any clues.