On an E27 - the wheel yoke housing, just below the wheel, where the emergency tiller is attached - where is the water supposed to go? My '75 E27 had about 2" standing water in this housing (so THAT is where the drip was coming from) and I had to mop the water out - no drain hole that I could see. The wood base mounts area nearly completely gone...
I will first assume there is a clogged drain, but where?
If there is no drain hole, should I assume this area is not ever supposed to get wet?
Would it be a bad idea to drill a hole on on the port side, thereby allowing water to drain into the rear-most bilge area near the fuel tank?
TIA,
- Jerry
I will first assume there is a clogged drain, but where?
If there is no drain hole, should I assume this area is not ever supposed to get wet?
Would it be a bad idea to drill a hole on on the port side, thereby allowing water to drain into the rear-most bilge area near the fuel tank?
TIA,
- Jerry