I'm putting in a new Facet Gold cylindrical fuel pump. The old pump used these brass compression fittings to mate with the installed copper fuel lines.
Do I need to buy new compression fittings (they will be mating with the same, original tubing I removed them from) or can I reuse these?
Also, do I install the fittings "dry," or use Permatex #3 sealant (or, other preferred sealant)?
Do I need to buy new compression fittings (they will be mating with the same, original tubing I removed them from) or can I reuse these?
Also, do I install the fittings "dry," or use Permatex #3 sealant (or, other preferred sealant)?
Last edited: