I recently purchased an E27. I have run the bilge pump about three times by turning the battery switch to on (1,2,or ALL) and then turning on the 10A switch on labeled "Bilge Pump Aft". This was with the 20A Main All turned to on.
Now when I trip the 10A switch it stays on for a few seconds and then the switch trips to off. Not sure where to start? Is there a fuse that is blown? Should I see if the bilge pump is getting power? The batteries are charged up so I am not sure what would cause a fuse to trip to off automatically.
Thanks for your help!
John
Now when I trip the 10A switch it stays on for a few seconds and then the switch trips to off. Not sure where to start? Is there a fuse that is blown? Should I see if the bilge pump is getting power? The batteries are charged up so I am not sure what would cause a fuse to trip to off automatically.
Thanks for your help!
John