I have an 1979 Ericson 29. The mast head sheave's (4), between 3 plates had a plate with some backing coming off. I re-glued the backing, and now the unit is two wide to easily fit back in the mast-head.
The sheave's do not turn because of this.
Question:
1. Where can I get replacment sheave's or
2. I can get a metal shop to grind off a few thousands of an inch on all four so that the total width is smaller and I will not have to force the unit back in.
Any suggestions would be greatly appreciated.
Randy Juhl
The sheave's do not turn because of this.
Question:
1. Where can I get replacment sheave's or
2. I can get a metal shop to grind off a few thousands of an inch on all four so that the total width is smaller and I will not have to force the unit back in.
Any suggestions would be greatly appreciated.
Randy Juhl