placement

Hi, Our E30+ came with 2 oval zincs placed about an inch apart on the drive shaft between the strut and the hull. There is no zinc on the bronze propeller or on the strut, or anywhere else (other than the pencil zinc in the heat exchanger). Lately, I have seen or heard of sailors placing...

Hi All, I've been waiting for our two group 31 / 12 volt house bank batteries to die so I can replace them with four 6 volt golf carts. They did just that on our holiday this summer. My problem is where to put them. The only place I can think of converting is the small space under the...

My 35-2 has what looks like the original engine starter panel in the helmsman's cockpit well on the starboard side. A tachometer is also in the well but it is mounted on the rear bulkhead facing forward (i.e., under the helsman's seat on the star. side). The tach is completely unreadable...

Hello Ericson Sailors-- I just got my asymmetrical spinnaker, and plan on flying it this weekend. I want to add a pair of cars and blocks on the tracks that run along the toe rails on both sides of the boat. Anyone know the track widths? Also, how far back should I position the sheet blocks?

Hello All-- I'm going to replace a corroded A-4 waterlift muffler. Right now, I've got an original "can style" above the waterline design. According to the Moyer Manual, if I want to buy an off the shelf muffler, I'll put a below the waterline system with an anti-siphon hose. My question...

I'm going up to do some work on our "new" E29 in about a month. The PO said that the lights on the mast did not work so we will be re-wiring the mast and replacing light fixtures. I know that we need a Steaming light for use under power. I keep seeing a reference to spreader lights. Could...

So, I got this good deal on a JRC 1800 radar for my 85 E38. Now I need to find a good spot for the display. Iam leaning toward a mount on the binnacle. Pros or cons? thanks, Hodo :devil:

A question for all you E-25 owners out there, where do you place the Jib blocks on the toerail? I have a 1977 E-25 with a roller furling 140 Jib and it's difficult to trim the jib with the block fixed in one position on the toerail. Currently the only way to adjust the block (fore and aft)...

Has anyone fitted a holding tank into a 35-2 ? Every place I've tried to fit one in seems too small to fit a 15 gallon tank.