Yep Loren,
I’d be happy with a positive report. Would make life a lot easier for me but unfortunately I’m at the mercy of an unknown yard. Which brings me here.
Thanks S. I’m fine with slow I’m even good with expensive as long as the workmanship is good. Taking her up to Canada is a compilation I’m trying to avoid but thanks for the info. I’m just trying to decide whether or not to stay with this company or no before I have to commit once the engine...
Thanks Loren,
i realize that many folks are reluctant to share negative or positive thoughts about particular service providers.
That said, I don’t know how to get any information one way or the other, as of now I’m just going on some negative dock scuttle butt.
I could post my personal email...
Thanks Loren,
Sea Marine was the shop recommendation for the sale by the beta distribution folks for the west coast so that’s who I went with but I’m a little nervous about the install. They haven’t been very responsive. I paid the deposit for this engine four months ago.
I’m doing an engine swap. Removing the universal for a new beta.
Ericson 32-2 Olympia. I’ve just spoken with a friend who has an islander who has some pretty negative things to say about te engine work they did on his boat. I’ve paid for the engine but not for the install yet.
Thanks any advice...
Thanks Christian and Bob,
So I checked the glow plugs reisitance was 1 on each so they look good with out pulling them. While pulling off the lines in my minds eye I see a couple of you laughing a little when I realized that removing the center one would I would have to loosen the intake...
Thank you Ken,
The information on the compression lever is very helpful. I will have to wire it open since I don't know where I can get this spring until I get back home. Too late on the warning not to move it, while cranking the engine I moved it to different postitions trying to figure out...
Found the spring in the parts book I think it's the decompression spring. Now the question is does anyone know what position that lever is supposed to be in? If it can be described?
I have good crank. I have changed filter and have bled air from system up to the knurled knob getting a good flow. I'm thinking at least one cylinder would fire I get nada. two things I don't know if they are relevant. One is that there is an arm bracket at the rear of the engine looking aft...
Gentleman,
This is such a useful conversation. It may be covering old ground but there are a lot of things in this thread that are looked at from different perspectives then the former conversations that are so helpful. It's clearing up a lot of questions I had in my head. Now if I could just...