rudderstock
- Thread starter mvilaret
- Start date
-
- Tags
- rudderstock
A measuring idea...
I had this problem some years ago with comfirming the OD of the prop shaft on our '88 Olson. At the time I did not own a caliper so I used the parralel (sp.) rule off the nav. table...
I held the parralel rule on the shaft, and measured across between the plastic edges. Worked "like a charm" as the saying goes.
Loren
I had this problem some years ago with comfirming the OD of the prop shaft on our '88 Olson. At the time I did not own a caliper so I used the parralel (sp.) rule off the nav. table...
I held the parralel rule on the shaft, and measured across between the plastic edges. Worked "like a charm" as the saying goes.
Loren
John Yandow
Member I
On Mean Jean, I re-did my rudder bearing with West System. I was going to replace the bronze bearing but decided not to. Anyway, I took my rudder out and miced the shaft, it had a 4" O.D. I'm not sure but I think your 38 may have the same DIA. shaft.