Hi everyone - I'm sure this a popular topic!
I have an Ericson 29 hull #190. I think that my holding tank is not original equipment and would like to replace it. The tank is a flixible tank installed in a locker in the forward half of the starbord setee. The access ports to the area are relatively small, and I've been a bit concerned about trying to fit an adequately sized hard wall tank in that area.
In my bilge there are support brackets which appear to have been used to hold some form of tank or another. I'm wondering if that might have been the location of the original tank. If anyone has any wisdom on this, I'd be greatful. I'm assuming that the fundemental design between the E27, E29 and E32 from a early 70's vintage is consistent, so comments from owners of those boats would be welcome as well.
regards,
I have an Ericson 29 hull #190. I think that my holding tank is not original equipment and would like to replace it. The tank is a flixible tank installed in a locker in the forward half of the starbord setee. The access ports to the area are relatively small, and I've been a bit concerned about trying to fit an adequately sized hard wall tank in that area.
In my bilge there are support brackets which appear to have been used to hold some form of tank or another. I'm wondering if that might have been the location of the original tank. If anyone has any wisdom on this, I'd be greatful. I'm assuming that the fundemental design between the E27, E29 and E32 from a early 70's vintage is consistent, so comments from owners of those boats would be welcome as well.
regards,