Shadowfax
Member III
OK, my engine temperature gage hasn't really worked in awhile, so in a maintenance frenzy I decided to fix it. I took the wire off the sending unit and grounded it and the gage went to below 0 degrees. I took this to mean that the gage itself worked. I replaced the sending unit, but to no avail.
Logic demands that either the wire is bad [doubt here], or the gage is in fact bad. I'll redo the wire connection at the sending unit just to be sure, but if that doesn't do it, I'm wondering if any replacement temperature gage will do it, or does the new temperature gage have to match the sending unit. I believe the stock Ericson gage was a Teleflex, please correct me if I am wrong. If this is the case does anyone know the correct gage that matches the Universal
M25 XP sending unit.
Thanks
Logic demands that either the wire is bad [doubt here], or the gage is in fact bad. I'll redo the wire connection at the sending unit just to be sure, but if that doesn't do it, I'm wondering if any replacement temperature gage will do it, or does the new temperature gage have to match the sending unit. I believe the stock Ericson gage was a Teleflex, please correct me if I am wrong. If this is the case does anyone know the correct gage that matches the Universal
M25 XP sending unit.
Thanks