View RSS Feed

Kenneth K

Another Engine Panel Upgrade Pt 3

Rate this Entry
Continued from Part 2.

Thought I'd post the final chapter of my engine panel upgrade. I finished the wiring back in May and have been happy with the results—mainly, no more surprises during engine start.

I had to design a new spray cover because I “flipped” the original panel upside down (to put the gauges at the bottom where they are easier to see). As Loren pointed out in a comment, you can't use the original T-shaped cover upside down, or it will trap water.

The solution was a 3-piece spray cover: 1) a U-shaped piece with no bottom edge to provide drainage, 2) the upside-down mounted T-shaped piece, and 3) a hinged cover to keep water and dirt from getting in there in the first place.

The panels are 3/16” plexi (vs the original 1/8” plexi) that I had cut at a local plastics shop. The hinge is stainless and without holes (so I could drill my own holes in various sizes, where I needed them) from McMaster Carr.

Click image for larger version. 

Name:	20191124_205428.jpg 
Views:	13 
Size:	42.4 KB 
ID:	28117


Click image for larger version. 

Name:	20191125_144817.2.jpg 
Views:	16 
Size:	73.9 KB 
ID:	28118 ..........Click image for larger version. 

Name:	20191125_150146.2.jpg 
Views:	15 
Size:	46.6 KB 
ID:	28120

The cover came out great, but the engineering of these one-off projects is always unforgiving. I originally had a thick, rubberized waterproof cover over the ignition key slot. The thick cover prevented the new hinged door from opening far enough, so I had to remove it. If I’d mounted the key-switch and USB charger a half-inch higher, I’d be able to open the cover fully, but as is, it opens only about 2/3, but far enough for easy switch access. Time to call this one good-enough......

Submit "Another Engine Panel Upgrade Pt 3" to Digg Submit "Another Engine Panel Upgrade Pt 3" to del.icio.us Submit "Another Engine Panel Upgrade Pt 3" to StumbleUpon Submit "Another Engine Panel Upgrade Pt 3" to Google Submit "Another Engine Panel Upgrade Pt 3" to Face Book

Updated 11-27-2019 at 01:38 PM by Kenneth K

Tags: None Add / Edit Tags
Categories
Maintenance and Mechanical

Comments

  1. Loren Beach's Avatar
    That nifty hinged cover looks sort of familiar...


    And of course I like it !!
  2. Kenneth K's Avatar
    The sincerest form of flattery......