• Recent Blog Posts

    texlan

    She's got sole!

    Floor frames were carefully measured and cut to float a cm off of the hull, glassed on both sides and epoxy sealed edges, then tabbed into place with 3 layers of 17 oz tabbing. A large 3/8" G-10...

    texlan 12-13-2019 07:40 AM
    texlan

    An uplifting change!

    I went ahead and glassed in the old engine controls panel hole and shifter/throttle hole, as they were located in prime leak water into the boat locations. There was also another hatch near the gas...

    texlan 12-11-2019 11:17 PM
    texlan

    Working through it

    This girl needed a real new lease on life. It needed a new backbone..err mast compression post step. It needed a new sole. We could rebuild her... we do have the technology. She could be more than...

    texlan 12-10-2019 10:40 PM
    texlan

    New beginnings

    Even though I'd stepped back, I did manage to, over a year or so, finish out the new sump and engine bay pretty nicely, and even got the nuisance pump (A whale 320 gulper with air pressure switch)...

    texlan 12-10-2019 09:27 PM
    texlan

    More Debuilding and some scope..

    I was starting to feel pretty good about the sump situation,



    but once you start cutting, it becomes an addiction. There was the Great Rotten Galley Removal of '17..


    The delaminated...

    texlan 12-10-2019 08:22 AM
    texlan

    More Problems -- Debuilding.

    So No Problem needed to come clean about it's past, and if I was ever to get my soon to be wife to come aboard, I had to fix the petrole-mold smell. Unfortunately, much of it was not visible...

    texlan 12-10-2019 07:59 AM
  • Donation Policy

    EY.o Donation Policy

    EricsonYachts.org is not a commercial website; it does not charge for the usage or dissemination of the information it provides, nor does it rely on commercial activity such as equipment sales or third party advertising to pay its costs.


    Starting in 2004, the EricsonYachts.org website became entirely reliant upon support from its users. Once a year we ask users to contribute to support this site. This takes the form of small donations which, with good turnout, manages to pay the annual hosting bill, URL payments and related software expenses of the site.


    If you would like to contribute, you may do so by either sending a check (made payable to Sean Engle) to the address shown below, or with a major credit card via Paypal through the link below.


    Inquiries on this policy should be made by emailing us.


    Thank you so very much for your gracious support of www.EricsonYachts.org!


    via check to:


    postal address


    or...


    paypal image