holly

What is the thickness of the existing sole on our boats, 1/4. 1/2. 3/4. Is the sole the standard 2-1/4 teak and 1/4 holly? It there a supplier that you would recommend? Thanks in advance

I have noticed that the teak and holly flooring on my E-28 could use a little "sprucing up" (no pun intended). It's not bad, just showing a little wear. Also it seems the softness of the teak has allowed a little bit of sand to get embedded into it in places or could I have not noticed before...

anyone have or know where i can get some scrap teak and holly flooring (other than ebay)? Just enuff to replace the bilge plates fore and aft of the mast in an e34.

I'm looking for 1/4 teak and holly plywood that someone may have left over from a cabin sole project. I need to replace two sections and can't justify purchasing a full sheet. Need two pieces.. one 31 x 16 and a second 36 x 13 I will gladly pay for the pieces in addition to S&H. The width of...

I have already read the tread on teak and holly floor replacement… A few simple questions that have not been answered, On the E 38-200 it appears that the plywood goes under the aft door way trim. If that is the case is it possible to redo the floor without removing the doors/trim? It...

Hi: I just purchased a 1988 Ericson 38-200 and love the boat. I have found that the Teak and Holly Sole creaks underway. I suspect a couple of things: 1. The screws below the bungs need to be tightened 2. The solid teak trim around the fall flexes against the teak furniture modules Has...