espar

Hi, I would like to install an ESPAR heater in my 1988 Ericson 38-200. I would prefer, but I'm open to other ideas, to install the heater in the starboard cockpit locker or in the aft locker. I was planning to run the exhaust out the stern, or possibly near the engine exhaust. I would prefer...

The boat went in late this season and I would really like to stretch my sailing into the fall/winter this year if possible. That means adding a heater to the boat. I was thinking bulkhead diesel but I can't commit to cutting that big a hole in the cabin top. Gives me shivers just thinking...

Hi, I am planning to install an Espar heater in our 1988 38-200 in the spring. However, I have thought about this before. I am hoping that someone has completed an installation in a similar boat and would be willing to share their knowledge. I am wondering which unit was chosen, were the...

Winter sailing is comming on fast and I still havent installed my furnace. Has anybody with a E27 or E29 installed an Espar, or similar furnace? I have some ideas on where to put the furnace, and the controller, and route the ducts, and such, but I'd really like to hear how others have done it...

I'm considering adding a heating system beyond my little force 10 propane to the boat. The local yards say going hydronic is the way to go since it only takes 3/4 copper opposed to 3 inch. Has anyone gone this route? I would put the unit in the back locker and plump it into my hot water...

I am a new member and just replaced a 21 year old Espar forced air furnace with a new one. If anyone out there is interested I have been there, done that.

Does anyone have any experience installing an Espar (Eberspacher) forced air diesel heater on their Ericson. We have purchased a D5L model on the used market and will be fitting it into our E35 II after the dealer has completed a bench test and service of the unit. My specific problem is how to...