Recent content by enrique

I have replaced all of my hardware except the fuel. Trying to figure out how to reach the hose clamps..Feeling awkward

Thanks will do

How much did it cost and who did it? Thanks

Aftmost Keelbolt I delivered my Boat from Ventura to Alameda, in front of Avila Beach in Very rough Seas we were pounding and the aftmost keelbolt sprang a leak. It was hand tight. Seeing 4 inches of sea water on the cabin sole at 2:00 Am can get ones attention. The Crew was asleep and...

Inspection Frequency I check at each haulout.

E-38 Keel bolts I second that recommendation Check under the keelbolts

Dodger e-38 Need to replace my dodger, Price of $2500.00 seems high. Anyone with a recommendation? SF Bay Area California

Keel Bolts How does one remove the Keel bolts? in Particular the trailing one aftmost on the E-38 1981? Are they threaded at both ends or is is some " L" type bolt?

I have seen a few E-38's with a windlass which fits nicely in the anchor locker. Does anyone have the model number Brand? thanks

Rub Rail & PC I found the IBM thinkpad 770 series will run most software and I can get them used for about $300.00 Getting my T-30 wet is an unappealing prospect. I have dropped one HP and for Boating I would have a couple spare laptops than to lose my best.

Bitter End As a compromise I attached a fender to the bitter end. Havent tested it to see how much line it will float but in about 50' of water it may float enough to retrieve.

5432 Prop I have a 5432 and a 3 Blade prop, I'm not sure of the pitch but the prop works well the engine turns at about 2100-2200 rpm increasing RPM beyond that does not result in any more speed. My Original 2 blade prop is on the boat as a spare. I suspect the smaller 2 blade would result...