• Untitled Document

    Join us on March 29rd, 7pm EST

    for the CBEC Virtual Meeting

    All EYO members and followers are welcome to join the fun and get to know the guest speaker!

    See the link below for login credentials and join us!

    March Meeting Info

    (dismiss this notice by hitting 'X', upper right)

conversion

  1. S

    Norcold conversion Refrigeration unit

    Hi all, We have a 1976 E-32. We are looking to install a refrigeration system to the icebox. I have looked on-line at various types of units and I am not sure which way to go, evaporator type or cold plate. I am interested in hearing pros and cons of each. I understand the running time of...
  2. C

    Conversion to Engineless Coastal Cruiser

    About a year ago, I purchased a 32 foot Ericson Yacht with a Universal Atomic 4 engine. Despite all efforts the Atomic 4 has failed me over and over again. I have the money to replace the Atomic 4 with a Diesel, but after becoming a fan of the Pardeys I've considered removing the Atomic 4 and...
  3. R

    Main sheet bridle conversion

    Hi, Our 1978 E34t's original traveler is located just aft of the companionway - great for sail handling, less than ideal for cruising with kids and dog. Last weekend we noticed an aloha that had a similar setup to ours, where the owners had moved the sheet to the cabin top using a bridle...
  4. A

    E29 Head Conversion

    I am wondering on any suggestions on replacing my head which is a standard discharge type head to like an electro scan or some other eco friendly solutions that could be done without a holding tank. P.s. Not to handy with a wrench may have to pay to have the work done so what would be the best $...
  5. S

    conversion of an E27 from Volvo to Electric propulsion

    Just converted Scandalous (E27) from gas to electric. Uses four lead batteries and is capable of hull speed. Using a 48 volt system and cost under 5K for the complete conversion. Located in San Diego. :egrin: Anyone considering this, I would be happy to advise. Don at postal6@juno.com
  6. W

    E 27 Conversion Tiller to Wheel WTB Tiller/Rudder Head

    Anyone out there have tiller parts after converting to wheel on an E 27???? Could really use tiller/rudder head for rebuild on E 23-1
  7. Afrakes

    E-27 Wheel Conversion

    I'm considering converting my E-27 from tiller to wheel steering. Has anyone has any experience with this kind of project?
  8. erikwfab

    Galley Maid alcohol stove conversion

    I have the origional 3 burner w/ oven alcohol stove aboard my 1976 E36C. I need to either convert the burners to propane or replace them with new alcohol ones. My problem is that the current burners are cast steel worn and dont burn clean. Because they do not burn clean,they soot up the...
  9. T

    23-2 Mainsheet traveler conversion

    Apparently, I have one of the few remaining 23-2's without a main sheet traveler. Just a padeye on the cockpit sole. Now that I have a new paint job, bottom paint, new main, and outboard motor, I guess its time to shake the piggy bank again and upgrade the sail controls. So all of you who have a...
  10. Salty Dawg

    Internal Halyard Conversion

    I'm going to be dropping the mast on "The Dawg" (for her annual rig inspection) and thought I might convert to internal halyards. Anyone have any advice.. Pros--Cons. Thought I might borrow a friends Plasma Cutter to cut the slots (:confused: can you use a plasma cutter on Aluminium?) Please...
  11. Steve

    Oil pressure gage conversion from light?

    Has anyone converted their idiot oil pressure light to a conventional gage? :confused: It's clearly comforting to see the actual pressures, like a car, if the light comes on, perhaps it's too late to prevent some degree of damage. Thanks, Steve Universal 5424 or M30 hard to tell...
  12. T

    CNG to Propane stove conversion parts

    Anyone know where to get these? I have an 89 E 38-200. I don't recall right now the stove manufacturer, I'll look tonight. I was hoping to not have to replace the whole stove. I know I will need some valves for the stove, a tank, boat already has the locker, new lines, and a solenoid. What else...
  13. gjersvik

    E-25 Johnson Extra Long Shaft Conversion

    SURPRISE Deux, an Ericson 25 would not make sternway no matter what I tried. While looking though the manual I found out that the boat should be powered with an extra long shaft outboard. The previous owner had this sternway problem too, only his solution was to go with more power, a 15 hp...
  14. 1973E29 TUG

    E29 Tiller to Wheel Conversion

    I recently purchased a 1973 E29 with a tiller and plan on doing some longer distance cruising and like the ease of wheel steering. I have thought about converting the tiller to a pedestal/wheel. What year/hull# did they start building the 29 with a wheel? Has anyone gone through converting...
  15. D

    Internal Halyard Conversion

    I have an E29 which I would like to convert to internal halyards. Anyone out there made this conversion? Anyone have any advise before I jump into this project? Dave
  16. S

    Raritan PHII head, conversion to electric

    The time has come to rebuilt the pump on our Raritan PHII manual head. While browsing the Port Supply catalog, I noticed there is an electric conversion kit available. Given that I'm willing to part with the $$$, does anyone have any coments about doing this. We have an E34 and do mostly...
  17. S

    Tiller-to-wheel conversion on a 28

    I am currently looking at a 1983 Ericson 28, but I want to convert the tiller to a wheel. Can anyone advise me on this. Thanks.
  18. jreddington

    Universal M-15 Fresh Water Conversion?

    My 1984 E-28 has an M-15 engine, (old model no 5411). My owners manual for the engine clearly shows that it is a salt water cooled engine. However, my engine definitely has a cooling circuit with an externally mounted heat exhanger. Did Westerbeke ever make a closed coolant circuit version...
Top