Keith Paremain
Junior Member
Fantastic website!
I am replacing the "crazed glass".
It is necessary to seperate the top and bottom halves of the frame.
The two halves are held together by detents swaged into a plastic piece that holds the halves together.
I can drill the detents out and seperate the halves.
Before I proceed! Can anybody advise how to rejoin the two halves?
It would seem that I should increase the detent holes in the plastic and then hammer in the aluminum.
Keith Paremain
"Excelsis" 32-3 Nepean Sailing Club & Gananoque Marina, Ontario, Canada
I am replacing the "crazed glass".
It is necessary to seperate the top and bottom halves of the frame.
The two halves are held together by detents swaged into a plastic piece that holds the halves together.
I can drill the detents out and seperate the halves.
Before I proceed! Can anybody advise how to rejoin the two halves?
It would seem that I should increase the detent holes in the plastic and then hammer in the aluminum.
Keith Paremain
"Excelsis" 32-3 Nepean Sailing Club & Gananoque Marina, Ontario, Canada