Clarime
Member I
Hello all
I am getting ready to run some new wire (wind sensor) through my mast and repair/replace some old wiring for lighting.
My question and hang up are getting the wire through the mast step and to the bottom of the boat to then run aft. The old wiring seams to run this way but a new wire (antenna) runs through the step and then along top of bulkhead to the side of the boat and then aft.
I would prefer to run them under the floor so that I don't have a bunch of wire running on the exterior of my bulk head.
Does anyone have any experience/advice with running the wires this way.
Thank you for all your help
Chris
I am getting ready to run some new wire (wind sensor) through my mast and repair/replace some old wiring for lighting.
My question and hang up are getting the wire through the mast step and to the bottom of the boat to then run aft. The old wiring seams to run this way but a new wire (antenna) runs through the step and then along top of bulkhead to the side of the boat and then aft.
I would prefer to run them under the floor so that I don't have a bunch of wire running on the exterior of my bulk head.
Does anyone have any experience/advice with running the wires this way.
Thank you for all your help
Chris