gulfcoaster
Member III
I checked front and back fixtures and wires including chasing all access points per the manual and can find no problems. If the port bow gets soaked, they trip in less then 2 minutes. If I turn them back on they trip immediately. I tried soaking just the port bow at the dock and they tripped. I think the problem is where the wire exits the port side of the bow pulpit and runs between the hull and anchor locker. I see I'll need to remove all the screws to pull out the locker to inspect the wire. My concern is the drain in the bottom of the locker itself. If anyone has any suggestions on this procedure, I'd sure appreciate the input. I even siliconed the light fixtures and entry points into the bow pulpit.