Here's my description of the port main bulkhead repair that I'm about 1/2 way through. I tried making a joint where the fiberglass was flush with the surface, but after I (and anything within 50ft, including a poor mallard swimming by) was covered with a 1/4" layer of sawdust after only completing 5% of the beveled surface, I gave up and prepared it as a butt joint. I'll have to put a veneer over it anyway because I used an less expensive douglas fir marine plywood rather than the crazy...
-
12399.jpg
47.5 KB · Views: 426
-
12400.jpg
92.1 KB · Views: 143
-
12401.jpg
99.6 KB · Views: 130
-
12402.jpg
50.4 KB · Views: 138
-
12403.jpg
71 KB · Views: 146