torque

I need to remove the nuts on two of my keel bolts to replace the corroded aluminum pates the P.O. had installed for load distribution. (right idea, wrong material). Assuming the bolts are in good shape, this should be one of the easier jobs this spring. Doed anyone know the torque setting for...

Does anyone know where I can find torque specs for an M25 for the following; Damper plate to flywheel Trans to bellhousing Bellhousing to engine block thanks,

Does any one have torque setting for exhaust manifold studs and nuts for 1982 M25. I believe studs and nuts are about 3/8 fine thread, not certain on size, they out on boat.

anyone know the keel bolt torque specs for a shoal draft E38, 1985?

Does anyone know the torque specs are for the eight 1-inch bolts and the four 1/2-inch bolts on an Ericson 34? Is it 250# for the 1-inch bolts and 125# for the others? Thanks. -- Brooke

Does any one know what the torque foot pound specs would be for keel bolts on a 1990 Ericson 28? I would like to tighten them up as routine maintenance on this fine vessel I just purchased. The diameter of the bolts are 1". Thank you in advance, Sam

I'm looking for information on how much torque to put on the keel bolts of my Ericson 35. Anyone out there have a clue? Thanks, drlmk@aol.com