setting

What sealant do you all use to set SS screws in aluminum mast? Thanks

I need to remove the nuts on two of my keel bolts to replace the corroded aluminum pates the P.O. had installed for load distribution. (right idea, wrong material). Assuming the bolts are in good shape, this should be one of the easier jobs this spring. Doed anyone know the torque setting for...

Does anyone have experience with the settings on a 2 blade Max prop? While bringing the boat home from New Jersey, I experience overheating when running above 2100 rpm. With load, the engine would only reach 2200. At first, I thought it was a heat exchanger issue. My experience with diesel...

Has anyone setup a wheel pilot on a 27 Ericson? I've got it all set up but am having problems with it holding course down wind and also when I'm motoring at over 4. knots it has problems once it's starts truing itself starboard. It continues starboard and tries to fight it's way back but it...

Does anyone know what settings work well for a 15 inch Maxprop when the engine is a M25XP Universal with a 2:1 Hurth transmission on an E-34? I tried 22 degrees, but the engine would not go past 2400 rpm. A distributor said "the Book" says to set the prop at ten degrees! That seems too low...

I have a E34 (1990) with a Universal M25XP and a Hurth 2:1 transmission. What pitch settings should I use on a 15 inch Maxprop? I had it at 22 degrees and could only get 2400 rpm. The book says it should be 10 degrees. That seems too low. Any thoughts?