Recent content by tim

I am selling my E-27 it is a 1974 model with roller furling, wheel steering, dodger. It is in good condition the interior has been recently reupolstered and I had the stove rebuilt. It has a palmer marine inboard engine that is running excellent. I hate to sell but I am not sailing enough to...

pedestol I also have a yacht specialties pedestol and need the whole linkage setup for mine. My controls are still in the cockpit. the phone# above did not work for me is it correct? I reached some investment firm.

The url is http://www.mcmaster.com scroll down to where they have the tools there they have the open end wrenches. The thin angle wrenches worked the best for me mine was frozen too. the part number if yours is 1 7/16" would be 5551a44. Good luck Tim Thurner

Thank you Sean for pointing out the document section I did not know it was there it helped alot. Also I found wrenches in a mcmaster carr catalog that work great for breaking the lock nut loose safely they are 30degreee angle pump wrenches mine were 1 7/16". They are small enough to work with in...

Does anyone else with an E-27 use any other size packing for their stuffing other than 1/8". I need to narrow it down because I need to replace the packing with the boat in the water. My boat has the 3/4" shaft so I am assuming it is 1/8" unless somebody knows that it might vary from one...

mainsail I am interested in your sail. could you give me the measurements so i can be sure they fit on my boat. Tim Thurner

My E-27 has gelcoat cracks along top edge of the transom and a little around the chain plates. I had a neighbor who is a composite engineer look at and tell me it is mostly superficial expecpt for the fact that not repairing it could lead to future problems due to water being able to work its...