Recent content by dustintodd

Also what mfg/model drive safer is that?

Do you have pictures of the bracket you designed to move the HX out of the way? Also according to North Atlantic Power Products, they have 2 different models depending on the bell housing mounting type BorgWarner or SAE-5. Still haven't figured out which I need for M25XP bell housing.

No mention of the bell housing mount type BorgWarner or SAE-5?

HBW50 replaced with Twindisc 40p This document is gold. Thank you.

HBW50 replaced with Twindisc 40p In both fwd and reverse?

My 1989 35-3 has a Universal M25XP mated to a HBW-50 transmission (that has failed). From reading all threads about this topic on this I am going with Twindisc tranmission to replace it (because it's cheap and good). But tried to figure out the exact model has been a challenge. I need to know...

HBW50 replaced with Twindisc 40p Bolo seems to have have a good experience with the Twindisc 40p. I made the mistake of doing HBW50 rebuilt and it has failed again just 3 seasons in. I don't want to eat the ZF costs. I like the Twindisc price. What did you end up doing?

When I got my E35III it had a Oceanair Systems marine AC unit. I didn't use it much but for heat in the boat yard during the winter. But I am going to need it this summer and the temp. sensor on the control panel systems to have gone dead as it always reports 32 degrees. I have been googling...

It seems like I could get the transmission off if I could reach the bolts with the right tool. Did they say why they had to pull the motor?

Since purchasing my 1989 35 mk3 8 years ago the transmission has leaked AT fluid pretty much constantly. In the last couple years the transmission has started to acting up. Primarily Oct/Nov when the weather gets cold. The symptoms only occur when the Universal M25XP is started up from sitting...

Using a multi-meter t-shoot the sender Anyone aware of a way to troubleshoot the sender using a multimeter? - Dustin

My temperature gauge is busted, was busted all last summer. Promised myself this would be resolved before I go back in the water. Does anyone have a link to a good article on the trouble shooting steps to be find the problem? I have never looked at this part of the diesel system and have no idea...

In fact I do I have a 6 foot section in the basement that didn't end up in the trash. I can cut off a small piece for you. Email dustintodd@yahoo.com to work out the details.

Model # I used A11-0711. But honestly I probably should have gone with a even profile vs. 711 profile which is designed for hull that is sloping away. It looks great vs. the old dented stuff I replaced. But it turns out most of my hull leaves the hull/deck join at almost 90 degrees. If I had to...

Replaced it with Taco Marine I pulled all the rub rail and replaced it with Taco Marine model. Could not match the old rub rail.