Recent content by chart_sailor

installation of ST2000 on E-25 If things go as planned, I will be installing an ST2000 on my E25 in another week or two. I'd be glad to submit some photos, etc. I thought I'd be using the cantilever off the vertical side, but I might to with the extensions and mount it higher. Years ago I...

other changes The big one was spending $ on a new harken roller furling and a new furling headsail. Also had the main cut to be loose footed and now have an outhaul that runs back to mast and down, to cockpit. Installed two "triple" sets of spinlock stoppers, so the main halyard, CB lift...

CB raising OK, looks like it posted this time. Had an existing line on hand and started by adding a double block, then later moved the double up top replacing the single, and installed a tripple at the bottom (cb cable end). since the cable end needs to drop "into" the fiberglass hull trunk...

test reply having trouble with posting/ log in , etc. send me email via jaylodge1@comcast.net if you get this post, and if you got my answer to your question about line length.

E25 CB changes made Purchased an E25 late in 07. One of the first things I did was add a double and a tripple block inside the compression area where the lift line attaches to the cb cable. I now have a 6:1 purchase BEFORE the line ever leaves the mast hole. Replaced the on deck wench w/ a...

might need a feedback servo installed on rudder post I purchased a new Jeaneau 37 in 2001 that came with the raymarine autohelm 4000, etc. Had the same problem. Was eventually told that the autopilot "head" is blind to "where" the rudder is unless you install the OPTIONAL rudder feedback...