Recent content by aaron

  1. A

    Forward jib track for ericson 27...where should it go?

    good point. It is a 95% crosscut for a standard rig, don't know the exact dimensions, but I will get them. THanks for you replies!
  2. A

    Forward jib track for ericson 27...where should it go?

    Hello, I am installing a forward jib track on my ericson 27, to help with pointing. My sail maker said to.put it a few inches inside the stay, but I am not sure how far forward /aft I should put it... any advice?
  3. A

    Jib track inside the rub rail on an Ericsson 27.

    Hello, my sail maker suggests I put a track for job fair leads on the deck, in board of the stays. Has anyone done this? Looking for pointers... Thanks! (1976 Ericsson 27)
  4. A

    E27 Tiller Fork

    Hey Randy, so the rudder head is 1 5/16 wide. the whole for the bolt is 2" back from the front of the head. it is just 1/4 " up from the base (see picture), most tiller forks I have seen are to wide to accommodate this.
  5. A

    E27 Tiller Fork

    any luck? Did you ever find anything that worked? I have also been looking for one of these for my ericson 27,
  6. A

    E27 tiller

    me too!! I am desperately seeking the same thing. Just curios what you did in the end for an emergency tiller.
  7. A

    Ericson 28 (and 27) Emergency Tiller

    ericson 28 emergency tiller Ok, I am in the same boat (no pun intended) these many years later...have an ericson 27, with a wheel and no emergency tiller..did you ever get an emergency tiller? I noticed a standard tiller strap won't work because, at least on mine the hole where the bolt goes in...
See more
Top